News

Community question of the week: Classic motion sensor with Hue lamp

It’s time again for the community question of the week. Today I would like to take care of the question of Ewi together with you, which in our community area was asked and already answered there. But as the saying goes: double is better than one.

I have a new home with existing motion detectors in the front room. Now I have installed Hue lamps, but the lamps reset each Mel when switched on. Unfortunately there are no flush-mounted motion detectors from Hue, but I don’t want to dismantle the existing motion detectors either. Do you have a solution for the problem?

First of all, it is of course never ideal when a classic motion detector is involved. This switches on the power supply to the connected lamp only when movement is detected. Conversely, this means that if no movement is detected, the Hue lamp is disconnected from the electricity and therefore cannot be reached.

For some time now it has been possible to set the switch-on behavior after a “power failure” in the lamp settings and thus have the lamps controlled by the classic motion detector “start” in a desired setting. In my experience, however, this does not work 100 percent reliably. In addition, the use of a smart light source is simply not intended.

From my point of view, there is no way around replacing the classic motion detector with a Hue motion detector. And even if there is no flush-mounted module, a suitable solution can be created with a little skill, as the community has already proven. Here a motion detector replaces it a light switch and here was a motion detector in a Gira frame built-in.


Source link

Admin

I started to play with tech since middle school. Smart phones, laptops and gadgets are all about my life. Besides, I am also a big fan of Star War. May the force be with you!

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button